Programming a Genie Intellicode Garage Door Repair can vary slightly depending on the specific model you have.

However, I’ll provide you with a general step-by-step guide that should work for most Genie Intellicode garage door openers. This guide will be concise and well under, but it should cover all the necessary information.

Before you start:

  1. Ensure that your Genie Intellicode garage door opener is properly installed and powered.
  2. Make sure you have the remote control or keypad you want to program with you.

Programming the Remote Control:

  1. Locate the “Learn” or “Program” button on your Genie Intellicode garage door opener motor unit. This button is typically on the back or side of the unit and may be labeled as such.
  2. Press and release the “Learn” or “Program” button. You’ll usually have around 30 seconds to complete the next steps.
  3. Quickly press the button on your remote control that you want to program. Hold the remote control close to the motor unit.
  4. You may see or hear a confirmation, such as the garage door opener light flashing or the unit making a clicking sound. This indicates that the programming was successful.
  5. Test the remote control by pressing the button you just programmed to ensure it opens and closes the garage door.

Programming the Keypad (Wireless Entry System):

  1. Locate the cover of the keypad on the outside of your garage door. You’ll need to open this cover to access the programming buttons.
  2. Open the cover and find the “Learn” or “Program” button on the keypad.
  3. Press and release the “Learn” or “Program” button. The keypad’s backlight may turn on, indicating that it’s in programming mode.
  4. Enter a personal PIN code of your choice on the keypad. It’s typically a 4 to 6-digit code, and you may need to press “Enter” or “OK” after entering it.
  5. Wait for a confirmation, such as a light flashing on the keypad, to indicate that the programming was successful.
  6. Test the keypad by entering your PIN code and pressing “Enter” or “OK” to see if it opens and closes the garage door.

Erasing Old Codes (Optional):

If you want to remove any previously programmed remote controls or keypads, follow these steps:

  1. Press and hold the “Learn” or “Program” button on the garage door opener motor unit until the indicator light turns off (usually about 6-10 seconds).
  2. Release the button. This erases all previously programmed codes.
  3. Re-program your remote controls and keypads as described above.

Programming Additional Remote Controls or Keypads:

To program additional remote controls or keypads, follow the same steps as above, starting with pressing the “Learn” or “Program” button on the garage door opener motor unit.

Final Testing:

After programming your remote controls and keypads, be sure to test each one to make sure they open and close the garage door as expected.

That’s it! You’ve successfully programmed your Genie Intellicode Garage Door Repair. If you encounter any issues or have a different model, refer to your specific opener’s user manual for detailed instructions.

Sanger Gates & Garage Doors

940-748-1866