Rewinding a Garage Door Repair Houston TX spring can be a tricky and dangerous task, requiring specialized tools and knowledge. The following is a guide with detailed instructions to safely and effectively rewind your garage door spring.
Before starting, it is important to note that garage door springs are under a lot of tension and can cause serious injury or even death if not handled properly. It is highly recommended to seek the assistance of a professional if you are not experienced in working with garage door springs.
Step 1: Gather the necessary tools To rewind a garage door spring, you will need the following tools:
- winding bars (2)
- vise grips (2)
- adjustable wrench
- sockets
- ratchet
- ladder
- safety glasses
- gloves
Step 2: Release the tension on the spring Before attempting to rewind the spring, you must first release the tension. To do this, follow these steps:
- Locate the torsion spring above the garage door. The spring is typically located above the center of the door, mounted to a metal shaft.
- Insert one winding bar into the winding cone on the end of the spring.
- Using the winding bar, turn the cone counterclockwise until the spring is fully unwound.
- Repeat this process on the other side of the spring.
Step 3: Remove the spring from the shaft Once the spring is fully unwound and the tension is released, you can remove the spring from the shaft. To do this, follow these steps:
- Use the vise grips to clamp onto the shaft near the end of the spring.
- Remove the bolts that secure the spring to the center bracket.
- Slide the spring off the shaft.
Step 4: Measure the spring length and wire size Before rewinding the spring, it is important to measure the length and wire size to ensure that you are using the correct replacement spring. To do this, follow these steps:
- Measure the length of the spring, from one end to the other.
- Measure the wire size by counting the number of coils in one inch of the spring. Use a micrometer to measure the diameter of the wire.
Step 5: Install the new spring Once you have obtained the correct replacement spring, you can install it. To do this, follow these steps:
- Slide the new spring onto the shaft, making sure that the stationary cone is facing the center bracket.
- Insert the bolts to secure the spring to the center bracket.
- Use the winding bars to turn the winding cones on the end of the spring clockwise until the spring is fully wound. The number of turns will depend on the weight of the garage door and the size of the spring. Check the manufacturer’s instructions for the correct number of turns.
Step 6: Test the garage door Once the new spring is installed and fully wound, it is important to test the garage door to ensure that it is functioning properly. To do this, follow these steps:
- Open the garage door manually.
- Use the garage door opener to close the door.
- Observe the door as it closes, making sure that it closes smoothly and evenly.
- If the door is not closing properly, you may need to adjust the tension on the spring. Refer to the manufacturer’s instructions for guidance on adjusting the tension.
In conclusion, rewinding a Garage Door Repair Houston TX spring is a complex and potentially dangerous task. If you are not experienced in working with garage door springs, it is highly recommended to seek the assistance of a professional. However, if you are confident in your ability to safely and effectively rewind the spring, follow the steps outlined in this guide to complete the task. Always prioritize safety and wear appropriate protective gear.
East Downtown Garage Door
4105 Leeland St, Houston, TX 77023, United States
1-713-322-7436