Leveling a Garage Door Repair Justin TX is an important aspect of maintaining your garage’s functionality and safety. A garage door that is not level can cause a range of issues, including difficulty opening and closing, uneven wear and tear, and potential safety hazards.

In this guide, I will provide a step-by-step process for leveling a garage door.

Before we get started, it’s important to note that this process can vary depending on the type of garage door you have. The following instructions are for a standard overhead garage door with torsion springs.

Tools and Materials:

  • Step ladder
  • Tape measure
  • Level
  • Adjustable wrench
  • Pliers
  • Hammer
  • Wooden shims
  • Screwdriver

Step 1: Disconnect the garage door opener To begin, you’ll want to disconnect the garage door opener to ensure it doesn’t accidentally activate while you’re working on the door. To do this, locate the emergency release cord on the garage door opener track and pull it down to disconnect the opener from the door.

Step 2: Check the door’s balance Next, you’ll want to check the balance of the door. This can be done by manually lifting the door halfway up and releasing it. If the door stays in place, it’s properly balanced. If it falls or rises on its own, it needs to be rebalanced by a professional.

Step 3: Measure the height of the door Using a tape measure, measure the height of the garage door on both sides. Make note of any discrepancies in height.

Step 4: Check the level of the door Using a level, check the levelness of the garage door. Place the level horizontally on the bottom of the garage door, and then vertically on the sides of the door. If the door is not level, note the difference in measurement.

Step 5: Adjust the tracks If the garage door is not level, it may be due to the tracks being misaligned. To adjust the tracks, use a wrench to loosen the bolts holding the track to the wall or ceiling. You can then use a hammer and pliers to gently bend the track until it’s level. Tighten the bolts back up once the track is level.

Step 6: Adjust the springs If adjusting the tracks doesn’t level the garage door, the springs may need to be adjusted. Do not attempt to adjust the springs unless you have experience doing so or are working with a professional. Torsion springs are under extreme tension and can be dangerous to work with.

Step 7: Use shims to level the door If the door is still not level, you can use wooden shims to level it. Place the shims between the garage door frame and the wall or floor to even out any discrepancies in height. Start with the bottom corners of the garage door and work your way up, checking the levelness of the door as you go.

Step 8: Reconnect the garage door opener Once the garage door is level, you can reconnect the garage door opener by pulling the emergency release cord back up. Test the opener to ensure it’s functioning properly.

In conclusion, leveling a Garage Door Repair Justin TX is an important maintenance task that should be performed regularly to ensure the safety and functionality of your garage. While this process can seem daunting, with the proper tools and instructions, it can be done quickly and easily. If you’re unsure about any aspect of the process, or if you encounter any issues along the way, don’t hesitate to contact a professional for assistance.

Justin Best Garage & Overhead Doors

940-532-5824