As a homeowner, I recently had to replace the bottom seal of my garage door. While it may seem like a daunting task, it was actually a relatively easy process that I was able to complete in a few steps.
Here’s how I did it according to Garage Door Repair Woodland Hills CA:
First, I measured the length of the existing bottom seal to ensure that I purchased the correct replacement size. I found a replacement seal at my local hardware store, but you can also purchase them online.
Next, I removed the old bottom seal from the bottom of the garage door. Using a pair of pliers and a flathead screwdriver, I carefully pried the seal out of the track. I made sure to be gentle and not damage the track or the door.
Once the old seal was removed, I cleaned the track with a clean cloth to remove any dirt or debris that may have accumulated in the track. It’s important to have a clean surface before installing the new seal.
After cleaning the track, I positioned the new bottom seal at the bottom of the garage door, making sure it was centered and straight. I then pushed the seal into the track, starting at one end and working my way to the other end. If needed, I used a rubber mallet to gently tap the seal into place.
Once the seal was installed, I trimmed any excess with a pair of scissors or a utility knife. It’s important not to cut the seal too short, as it won’t provide a tight seal if it’s too small.
Finally, I closed the garage door and tested the new seal by running my hand along the bottom of the door. I made sure that the seal was tight against the ground and that there were no gaps.
Overall, as per Garage Door Repair Woodland Hills CA, replacing the bottom seal of my garage door was a simple process that only took a few steps. By doing this, I was able to help keep out drafts, pests, and moisture, and improve the energy efficiency of my home.
Warner Center Garage Doors
Woodland Hills, CA 91365
818-514-7622